Seismic Lokton Griptape 10cm

2.20

Kogero rimčiausias griptape’as rinkoje. Skirtas tiems, kurie nori, kad kojos ant lentos laikytųsi it prikaltos.

Nurodyta kaina už 10 cm. ilgio atkarpą. (Plotis 28cm / 11″)

*Neatlaidus klaidoms klijuojant ant lentos. Nuoširdžiai rekomenduojame sekti visomis gamintojo rekomendacijomis siekant geriausio efekto.


Noticeably sharper, tougher, and grippier. Grit stays ultra-sharp, doesn’t flake off. No smearing or peeling, even in heat or rain. The best grip in the history of grip. Lock in with Lokton™!

Apply Lokton only to clean, dry deck surfaces at room temperature. For best results, follow these directions:
1) If deck is coated with excess lacquer, buff with fine sandpaper and clean off residue with Naptha.
2) Use a blow dryer or heat gun to gently warm up Lokton after removing release paper but before placing on deck.
3) Place on deck, then immediately apply pressure by standing on all areas of the Lokton.
4) Trim edges by cutting from the top. Do not bend or file edges, as this can cause excessive grain shedding.

Lokton does not always adhere well to the top of other grip tape, but it will conform to the contours of most concaves and implants. The Ninja lasercut conforms more easily to deeper concaves.

The PSA (pressure-sensitive adhesive) on the back of Lokton is some of the best, most heat-resistant on the market. However, it does not always bond well to unusual combinations of deck-top materials and finishes, especially certain types of Formica and heavy lacquer. Your results may vary.

Out of stock